Paralenz Vaquita 2nd Gen, User Manual

Page: 48 / 62

48
All waters look murky with a dirty lens! Make sure your lens is clean and
has no scratches. To clean the lens, wipe it with a soft, lint-free cloth.
You can use Eyeglass Cleaning Fluid. Do not use strong solvents such as
benzene or alcohol.
Check that the O-Rings have not been stretched and do not have any
cuts, tears, or dirt (hair, dust). To lubricate the O-Rings, apply a thin layer
of silicone-based grease and run them through your fingers while gently
rubbing the grease into the O-Ring (do not use spray lubricant or petrole-
um-based grease).
Maintenance
The triple O-Rings are tested to 350 m/1150 ft./36 ATM. You should be
fine as long as you properly maintain the O-Rings and don’t open the
camera underwater. Remember to put the End Cap on correctly.
We recommend rinsing the camera in fresh, warm water while moving the
Selector Ring and Activation Switch. No solvents or chemicals should
be used while cleaning. If sand grains should get stuck underneath the
Selector Ring, please contact our support for instructions.
Cleaning the camera
How do I prevent the camera from flooding?
Cleaning the O-Rings
Cleaning the lens
You can find more info in our Support Center.
Scan the QR code to get to the Paralenz Support
Center.