background image

6.

 

In operation, the floss will collect on the mesh stabilizer inside the bowl. If the floss collects 

“low” on the netting, twist the front (leading) edge of the  

leather floaters down. You get more lift and the floss will collect higher. 

 

 

 

 
For video demonstration on how to make floss, go to 

https://www.youtube.com/watch?v=G25raDlY0D0

 

It’s not the same model of cotton candy machine but the general idea is there.  

Summary of Contents for Classic Floss 5

Page 1: ... the ON position 8 Turn the HEAT CONTROL knob to setting HIGH 9 Once floss starts to flow out of the head reduce the HEAT CONTROL accordingly Note Too high of a setting will cause cutting of the floss and potentially clog the screen assembly 10 When the amount of floss that is being produced starts to slow add more sugar DO NOT adjust the HEAT CONTROL knob setting Shutting Down 1 Press the HEAT sw...

Page 2: ...ining nuts and leather floaters on the top of the SPINNING HEAD unit 4 Remove the top from the SPINNING HEAD unit by lifting it off 5 Remove the slinger plate by losing the two nylon acorn nuts in the center 6 Disconnect the two heater lead terminations by removing the two nuts 3 8 hex and removing the leads from the studs 7 Remove the outer screen assembly with the heating element by sliding it s...

Page 3: ...ne up with the ring of floss attached and rotate the cone to wrap the floss DO NOT roll floss while the cone is inside the pan This will pack the floss too tightly 4 If the floss fails to stick to the cone pass the cone near the spinner head to pick up a starter of melted sugar Lift the cone out of the pan and wrap the floss with a figure eight movement of the hand This leaves giant pockets and ma...

Page 4: ... low on the netting twist the front leading edge of the leather floaters down You get more lift and the floss will collect higher For video demonstration on how to make floss go to https www youtube com watch v G25raDlY0D0 It s not the same model of cotton candy machine but the general idea is there ...

Reviews: