Installing and Connecting the Hardware
2-9
8800-A2-GN21-20
October 1997
Installing the Chassis Set Back 3 or 5 Inches
The chassis may be installed with a 3- or 5-inch set back in either the 19- or
23-inch rack.
"
Procedure
1. Remove the screws that attach the mounting brackets to the sides of the
chassis.
NOTE:
Only two screws are used to attach the bracket on the left side for flush
mounting. A third screw, necessary for set back mounting, is already
installed behind the left bracket near the top of the chassis. Remove this
screw and save it.
97-15701
Third Screw
for Set-Back
Installation
2. Position the brackets set back 3 or 5 inches from flush mount. (Refer to
procedures for reversing brackets if installing in a 23-inch rack.)
3. Use three screws on each side to attach the brackets in the set back position.
4. Follow the procedures for installing the chassis in a 19- or 23-inch rack.
