Customizing V.35/V.11-Compatible Units
5-2
7915-A2-GB20-20
September 1997
Enter “?” to redisplay the menu.
The CP unit is also known as an SDSL Termination Unit - Remote (STU-R). A
unit on the CO side is an SDSL Termination Unit - Central (STU-C). Option 6
on the Main Menu varies according to unit type: on a CO unit it is used to
monitor the CP unit (STU-R) and on a CP unit it is used to monitor the CO
(STU-C).
This guide depicts the system terminal menus as they appear from a CP unit.
This is the default configuration for Model 7915 standalone units.
Making Changes from the Terminal Interface
The Board Configuration menu displays how the board is currently configured.
It also allows you to change certain parameters on the board.
When operating in Terminal Mode (the system default) you can make
configuration changes through the terminal menus.
When operating in Switchpack Mode, you can display configuration
parameters using the terminal menus, but any configuration changes must be
made using the switchpacks and jumpers on the board hardware. Refer to
Making Changes in Switchpack Mode
on page 5-5.
From the Main Menu, select option 3, Board Configuration.
The following example shows the Board Configuration displayed for a CP unit
(the default card type for standalone units). CP units always use the SDSL local
loop as the timing source.
Command
→
3
Board Configuration:
1)
SDSL Card Type – CP
SDSL Interface
– V.35
2)
Payload Rate
– 512 Kbps (8x64)
Timing
– Loop
SDSL FW Rev
– 4.3
Globespan FW Rev – 1.12
CP Serial #
– 85649
–––––––––––––––––––––––––––––––––––––––––––––
1–2) Board
Configuration
3) Switchpack
Definitions
?)
Prints Board Configuration and this menu
Q) Quit
Config
→
