Paradyne Hotwire 6301, User Manual

Page: 87 / 126

A. Command Line Interface
6371-A2-GB20-20 May 2001
A-21
show ip route
[ ip-address ]
Minimum Access Level: Operator
Command Mode: Standard
If an IP address is not provided, the entire table will be displayed with the upstream routes
displayed first and the downstream routes next. If the IP address is provided, only the
specific entry will be displayed. If the next hop IP address is 0.0.0.0, the host is directly
reachable on the Ethernet interface (eth1).
Sample
show ip route
display:
source ip-addr source subnet-mask nexthop ip-addr interface
x.x.x.x x.x.x.x x.x.x.x dsl1
dest ip-addr dest subnet-mask nexthop ip-addr interface
x.x.x.x x.x.x.x x.x.x.x eth1
show log
[
number
]
Minimum Access Level: Operator
Command Mode: Standard
Displays the contents of the local system error log. (The 100 most recent SYSLOG entries
are kept locally.) You specify the number of entries you wish to view. Entries are displayed
in reverse order, from the most recent to the oldest.
number – Number of local entries to be viewed. The default is 10, with a range of 1–100.
NOTE: The locally retained SYSLOG will be reset at the DSL router if the
restart
command is issued. External logs are retained after a DSL router restart.
show nat basic
Minimum Access Level: Operator
Command Mode: Standard
Sample
show nat basic
display:
NAT basic
–
{enabled
|
disabled}
NAT basic
–
public network address: x.x.x.x
NAT basic
–
public network mask: x.x.x.x
NAT timeout: xx minutes
NAT basic mappings:
public ip private-ip
x.x.x.x x.x.x.x
show nat napt
Minimum Access Level: Operator
Command Mode: Standard
Sample
show nat napt
display:
NAT NAPT
–
{enabled
|
disabled}
NAT NAPT
–
public IP-address: x.x.x.x
NAT timeout:
xx minutes
NAT NAPT mappings:
private-ip private-port mapped-port protocol
x.x.x.x xxxx xxxx {udp
|
tcp}