Paradyne GranDSLAM 4200, User Manual

Page: 62 / 382

3. ADSL Facility Commands
3-26
August 2002 4200-A2-GB20-00
ENT-PROFILE-ADSLALM
The ENT-PROFILE-ADSLALM command allocates a new ADSL alarm
configuration profile. A new ADSL alarm profile is created using the following
steps:
1. Allocate a new profile with ENT-PROFILE-ADSLALM .
2. Configure downstream transmission parameters with
ED-PROFILE-ADSLDNALM .
3. Configure upstream transmission parameters with
ED-PROFILE-ADSLUPALM .
4. Activate the profile with ACT-PROFILE-ADSLALM .
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* ENT-PROFILE-ADSLALM:[tid]:[adsl_profile_id]:[ctag]::
profile_name */
;
Table 3-21. ENT-PROFILE-ADSLALM Command Parameters
ENT-PROFILE-ADSLALM:[tid]:[adsl_profile_id]:[ctag]::profile
_name;
RESTRICTIONS: Valid only for profiles with LOCAL scope. All parameters in this
command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
adsl_profile_id ADSL profile index (1
−
30). The profile must not already be in use.
Profile 1 (a predefined profile shipped with the system) is the default
and is always active. If no adsl_profile-id is specified, the next available
index will be assigned.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
profile_name Name (1
−
32 characters) that uniquely identifies the profile