8
Installing and Setting Up the FrameSaver SLV
To complete the installation, you must:
Configure the FrameSaver unit.
Connect to the network.
Configure SNMP Trap Managers.
Connect to the DSX, if applicable (FrameSaver 9124, 9126, or 9128 only).
Connect to the DTE.
Connect to the modem (FrameSaver 9126 or 9128 only).
Connect to the ISDN, if applicable (FrameSaver 9126 or 9128 only).
NOTE:
Follow these instructions as they are presented. Installation time will be increased
if you connect the cables first.
Verifying that Self-Test Passed
Before starting to configure the FrameSaver unit, confirm that the unit passed the
self-test.
1. Follow this menu selection sequence from the Main Menu, pressing Enter after
each selection:
Main Menu
→
Status
→
System and Test Status
2. Check the Self-Test Results column (in the center of the System and Test Status
screen).
– If Passed appears, the FrameSaver unit successfully completed the self-test.
– If any failure messages appear, reset the unit by disconnecting, then
reconnecting the power cord. The unit will perform the self-test again. If the
failure reappears, call your service representative for assistance.
