Control Branch
7-13
3910-A2-GN32-40
September 1998
Access Disabled
The remote modem’s Access from Remote configuration is disabled.
Password Invalid
The local and remote modems’ passwords do not match. Correct the
problem and attempt another download from the local modem. If this
fails, contact your service representative.
No Circuit
There is no connection between the local and remote modem.
After successful establishment of a Remote Cloning Download session, the following screens
appear.
F1
RemClone Status
Initializing
F2
F3
F1
RemClone Status
Bank1:xxxx/yyyy
F2
F3
As data banks are transferred, the local and remote LCD’s bottom line displays the status of the
download process, and the number of records sent versus the total number of records for that
bank.
For Single download applications, if the download is successful, the local modem displays
Remote Clone OK and the remote modem displays Frmware Upgrade. If the download took
place over the dial network, the modems disconnect when the download is complete.
If the Single download is unsuccessful, RemClone Failed appears on the LCD’s top line.
Attempt another download from the local modem. If this fails, contact your service
representative.
VF Thresholds Update
The VF Thresholds Update function allows you to set the thresholds that determine the Health
and Status alarm conditions for the VF parameters. The following thresholds may be edited:
RSL High, RSL Low, Sig/Noise, NonLinear, Retrains/15min, Signal Quality, Near Echo, and
Far Echo. (For Health and Status alarm conditions, refer to Table 4-1 in the Device Health
and Status (DeviceHS) section of Chapter 4, Status Branch.)
To access VF Thresh Update from the Control branch, make the following selections:
F1
Control:
<
VF_Thresh_Update
F2
F3
