3. Cabling: Line Card Tip and Ring
3-4
November 2004
8820-A2-GN20-80
Cable Management Brackets
Two cable management brackets are attached to the rear sides of the BAC in the
shipping position (with the open slots facing forward).
Procedure
To install the cable management brackets:
1. Remove the screws (three on each) from the cable management brackets, and
then remove the cable management brackets from the chassis. Reposition the
brackets so that the open slots face the rear.
2. Reinstall the screws in the same holes to secure the brackets to the chassis.
When you have correctly installed the cable management brackets, ten slotted
holes are exposed at each side to accept the cables and the bushings.
00-16292-02
Cable
Management
Bracket
18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
Summary of Contents for 8820
