Paradox R885S, Installation And Operating Instructions Manual

Page: 9 / 32

R885S 7
FEEDBACK
Depending on the programming mode chosen,
the feedback will differ. In the section
System
Programming on page 9 and Master Programming
on page 16, the combinations of visual feedback
and beep tones are specified step by step.
Visual Feedback : When information is entered
on the reader’s keypad, the red and/or green
LEDs will flash, turn ON or turn OFF depending on
the step reached in programming.
Confirmation Beep : When an operation is
successfully entered, the reader emits a rapid
series of beep tones (“beep-beep-beep-beep-
beep”).
Rejection Beep : When the system reverts to a
previous status or an operation is incorrectly
entered, the reader emits one long beep tone
(“beeeeeeeeeep”).
RESETTING TO DEFAULT
To reset all sections to factory defaults,
disconnect reader’s power supply. Press and hold
the
[1] and [2] keys simultaneously while re-
connecting its power supply. The reader will emit
a confirmation beep. Repeat this procedure a
second time holding the
[3] and [4] keys.
Sections are reset when the reader emits the
second confirmation beep.