10
11
ASSIGNING DETECTORS & DOOR CONTACTS
In order to trigger the receiver’s zone outputs, each transmitter must be assigned to
an available (empty) zone output. Every time the tamper switch on a transmitter is
pressed, it will send its serial number to be registered in the selected zone output.
4.1
Automatic (Plug & Play) Zone Assignment
For U.S. versions, please refer to shaded box on the following page
[
ENTER
]
+ Installer Code +
[
MEM
]
+
[1]
The receiver can be set to automatically assign transmitters to the receiver’s zone
outputs in chronological order. After entering this mode, the
[
ENTER
]
and
[
MEM
]
keys
will flash to indicate that you can remain in this mode until you have completed all
required zone assignments. The keypad will display the zones that have already
been assigned by illuminating the corresponding key. Any unlit keys represent zone
outputs that have not been assigned a transmitter or have been reserved (see
Supervision Features
in section 6 or
Remote Control Assignment
in section 5).
When the tamper switch on a transmitter is pressed, the receiver will search for the
first unused zone output (1 to 12) and assign the transmitter’s serial number to that
zone (illuminating the corresponding key). To exit the Automatic Zone Assignment
Mode, press the
[
ENTER
]
or
[
CLEAR
]
key.
Example: Two transmitters are being added to an installation consisting of four
transmitters, which have been assigned zones 1 through 4. Set the receiver in
Automatic Zone Assignment Mode by pressing
[
ENTER
] + Installer Code + [
MEM
] +
[1]
. The [
ENTER
] and [
MEM
] keys will flash and keys [1] through [4] will be lit to
indicate transmitters have been assigned to these zone outputs. When the tamper
switch on one of the additional transmitters is pressed, the receiver will
automatically program the transmitter into the next unused zone output, that being
zone output 5. Press the tamper switch on the following additional transmitter and
the receiver will program the transmitter's serial number into zone output 6. The [5]
and [6] keys will illuminate to indicate successful zone assignment.
To enter a zone assignment mode, press:
[
ENTER
]
+
Installer Code
+
[
MEM
]
+ available
Modes
will flash (see below)
3.3
System Reset
Performing a system reset will set all addresses including the installer code to
factory default. The installer code will reset to 747474, all keys in address 014 will
reset to off.
Address 010, 012 and the current zone assignments will not be
affected.
To execute a system reset perform the following:
1) Make sure the installer lock is disabled (see section 3.2).
2) Remove the power connections ("+12" & "
GND
") from the receiver.
3) Place a jumper on the reset pins (JP3) of the receiver.
4) Re-connect the power connections to the receiver.
5) Wait 10 seconds and remove the jumper.
Libeei03.qxd 02/28/2001 11:53 AM Page 10
