Paradox Digiplex Liberator DGP-319, Installer'S Manual

Page: 9 / 37

10 Installer’s Guide
3.3 C
HECK
-
IN
S
UPERVISION
SECTION
[001]:
OPTIONS
[2]
AND
[3]
The Liberator Wireless Bus Module waits for each of its assigned detectors and/or
contact switches to send a status signal within a specified time period to confirm
their presence and functionality. If a device has not sent a signal within the time
period, the Receiver Module will automatically transmit a signal to the control panel,
which it can recognize a supervision loss. Option
[2] enables the Check-in
Supervision feature and option [3] specifies the time period required for the devices
to send their signal.
From Step 6 in Figure 3-1, page 8, enable or disable the options:
Option [2] OFF = Check-in Supervision disabled
Option [2] ON = Check-in Supervision enabled (default)
Option [3] OFF = Check-in every 12 hours (default)
Option [3] ON = Check-in every 12 minutes
3.4 T
AMPER
S
UPERVISION ON
R
ECEIVER
M
ODULE
SECTION
[001]:
OPTION
[4]
If this option is enabled and the Receiver Module's cover is removed, the on-board
tamper switch will be triggered. The Receiver Module will send a signal to the control
panel, which it will recognize as a Module Tamper.
From Step 6 in Figure 3-1, page 8, enable or disable the option:
Option [4] OFF = Receiver Module's Tamper Supervision disabled (default)
Option [4] ON = Receiver Module's Tamper Supervision enabled
I319EI01.fm Page 10 Wednesday, September 29, 1999 10:56 AM