7
8
.
Connect the left black screw fitting
(connected
to the blue heater)
to the corresponding fitting
coming from the tub
and tighten up with polygrips.
9
.
Connect the LED light and touch-pad wires
into the control box (refer to
the instructions on page 8 in the manual)
10
.
Open the filter air bleed valve
.
11
.
Fit the pressure guage
to the top of the filter lid.
12
.
Fill tub with water
and
close off air bleed valve
once water squirts out.
13
.
Plug in the pump unit
and
turn on
.
Adjust the temperature and filtering times to suit your lifestyle. Once you find
what works for you, everything should become automatic.
If you have ordered a tub that has an internal cedar wall/floor panels or a tub
without polyurthrene on the cedar seats, non-harmful tannins will leech from
the cedar, causing the water to discolour. This is completely normal and you
can continue to use the tub during this period. It is recommended that you
change the water and clean the filter more frequently until there is no more
discolouring (which may take up to 1 year to fade away).
3hp 2-speed pump
• The 3hp pump has a 2 speed motor for more efficiency and quietness. The
1st or low speed is run most of the time for heating and filtration. If wanting
extra pressure from the jets when inside the tub, push on the touch-pad for
the 2nd or high speed
• The pump unit needs to be covered and protected from the weather.
• Access is needed to the pump unit for any servicing and also to clean the
cartridge in the filter.
•
NEVER
run the pump without water!
