5
Fig. 4d
(Before wiring speaker see note on Fig. 4d – 1 below)
CONNECTING SPEAKER
Pull cables through center hole in bracket and connect speaker following the information on Page 9.
ADJUSTING THE SPEAKER’S ANGLE OF TILT
The self-adhesive bumper pads
(included) allow you to adjust the angle at which your speaker sits on the wall:
• To further optimize clarity, intelligibility and timbre you may tilt the speaker 7° up (Fig. 4d – 1) or 7° down (Fig. 4d – 2)
positioning the self-adhesive bumper pads marked 7°
(as shown).
• You can also mount the speaker parallel to the wall (Fig. 4d – 3), positioning the self-adhesive bumper pads
marked 0°
(as shown).
Adjustment should be done before mounting speaker:
Fig. 4e
Align keyhole slots
(shown at right) on rear of speaker with protruding screw heads on bracket, then using an
“in-and-down” motion mount speaker on bracket.
Inset
Keyhole slots
Fig. 4d – 1
To tilt speaker up, rotate speaker
180° then attach the self-adhesive
bumper pads marked 7°,
(as shown).
Fig. 4d – 2
To tilt speaker down
, attach the self-
adhesive bumper pads marked 7°,
(as shown).
Fig. 4d – 3
To mount speaker parallel to the
wall, attach self-adhesive bumper
pads marked 0°,
(as shown).
NOTE:
Rotate speaker
before wiring!
POSITIONING BUMPER PADS
Perspective in images at left shows
only one bumper pad. Two pads are
required, positioned as shown on
the lower recessed areas
(shaded
areas) of the keyhole slot sections
(see Inset below).
