7
2. Connecting and Installing
(continued)
Installing:
b) Holding the speaker’s front lip with your thumbs and index fingers, push the mounting screws toward
each other with your other fingers so that the brackets fit through the hole. Release the screws and
gently push the speaker to the wall/ceiling. (Fig. 5a)
While holding the speaker in place, alternately tighten each screw until the speaker is
firmly installed. (Fig. 5b)
Round and Square Speakers
With grille removed and bracket attached to speaker, place complete assembly to the wall or ceiling and …
Connecting (except models with ‘SM’ in their name, see connection instructions farther below):
a) Connect speaker cable as outlined on page 6, Fig. 8a, in section on Rectangular Speakers.
Installing:
b)
For Speakers With Two Mounting Screws:
Holding the speaker flange with your fingers, push on the
screw heads with your thumbs to extend rear bracket. The bracket is oblong, extending past each
screw. Fit one oblong end into the hole far enough to allow the other oblong end to also fit into the
hole. (Fig. 6a)
For Speakers With Four Mounting Screws:
Holding the speaker’s front lip with your thumbs and index
fingers, push the mounting screws toward each other with your other fingers, so the mounting
brackets can fit through the hole with an “up-and-in” motion. Release the screws and gently push the
speaker to the ceiling/wall. (Fig. 7a)
Models with Guided Soundfield
™
: Rotate the speaker so that the drive assembly points in
desired direction
(not shown).
c) While holding the speaker in place, alternately tighten each screw until the speaker is firmly
installed. (Figs. 6b and 7b)
Connecting ‘SM’ Models
Stereo Input (Single Speaker)
(Fig. 8b): Connect one speaker channel at a time to your receiver/amplifier.
Connect the Right red (+) amplifier terminal to the Right red (+) speaker terminal and the Right black (-)
amplifier terminal to the Right black (-) speaker terminal. Connect the Left red (+) amplifier terminal to the
Left red (+) speaker terminal and the Left black (-) amplifier terminal to the Left black (-) speaker terminal.
Follow the installation instructions provided earlier.
Mono Input
(Fig. 8c): Connect one speaker at a time to the left and right channels of your receiver/amplifier.
First, convert the Right speaker to Mono: Using a short piece of cable, connect the Right red (+) speaker
terminal to the Left red (+) speaker terminal and the Right black (-) speaker terminal to the Left black (-)
amplifier terminal. Then …
Connect the Right red (+) amplifier terminal to the Right red (+) speaker terminal and the Right black (-)
amplifier terminal to the Right black (-) speaker terminal.
Repeat entire procedure for Left speaker, then follow installation instructions provided earlier.
3. Installing the Grille
Press the grille into the groove on the front face of the speaker
(not shown)
.
