Page 6
PaperFolder.com
IF YOU ARE INSTALLING THE PH-14 WITH A STACKER OR KNIFE FOLDER
You will not be using either the output tray or the wheels on the PH14. However, you need to test the
machine to make sure it works properly before installing the Knife folder or the Stacker. INSTALL THE
OUTPUT TRAY ONLY (no wheels) AS SHOWN ABOVE TO TEST A FEW SAMPLES. When you have it folding
properly, remove the tray when you attach either the Knife folder or the Stacker.
The output tray will be installed on the Knife folder (see below), but it is not used with the Stacker.
WHERE TO SET THE FOLD
The length of each fold is set on its fold plate. You are setting the depth of the paper that will go into
the fold plate for that fold. For example, on letter size (8.5" x 11") paper:
For a half-fold, set the plate at 5.5".
A Z fold is 1/3 of 11" or 3.67" so set the plates at 3.67" on plates 1 and 2.
A 4 panel fan-fold is 1/4 of 11 or 2.75" so set the plates at 2.75" on plates 1, 2 and 3.
A 5-panel fan-fold is 1/5 of 11 or 2.2" so set the plates at 2.25"on plates 1 through 4.
For other size paper, you would divide the length of the paper by the number of panels you want
and set each fold plate accordingly.
IF A FOLD PLATE IS NOT NEEDED, IT MUST BE CLOSED. To do this, you reverse the fold plate as shown
below.
