PAP Team TINOX, User Manual

Page: 20 / 30

2.1. ATS INSTALATION
1.- Remove the carabiner where the paragliders risers are attached.
2.- Place the ATS on the arm with the regulation screws looking towards the
inside of the harness (fig 01).
3.- Pull the paragliders attachment loop through the hole on the top part of
the ATS (fig 02).
4.- Put back the carabiner in its position. (fig 03).
5.- Pull the arm to its maximum, by pulling the carabiner upwards (fig 04).
6.- Sliding the ATS forwards or backwards, seeking the best verticality of the
paraglider attachment Loop (fig05) and (fig06).
7.- Once having done this, fasten the 2 screws on the side (fig07).
(fig
01
)
(fig
04
) (fig
05
) (fig
06
)
(fig
02
)
(fig
03
)
(fig
07
)
REMEMBER THAT NOW
THE BALANCING POINT IS
THE TOP PART OF THE ATS
WHERE THE PARAGLIDERS
ATTACHMENT LOOP GOES
THROUGH , SO MOVING
THE SHACKLE HAS NO
INFLUENCE IN YOUR
POSITION DURING FLIGHT.
(fig 05) (fig 06).