16
PROGRAMMING
Positions:
Set „Program“ switch on front panel to „ON“.
a. Use manual control switch to select the sledge height that will serve
as starting point. Press the key marked STF to enter the first point
(starting point) in the program memory. (When STF is pressed, only
the starting point is memorized, and any existing programs are
erased.)
b. Use the manual control switch to bring the sledge to the next desired
point (= first stopping point). The Panther electronics will memorize
only the highest speed used to reach this point manually, and will
repeat the move at this speed throughout. If you wish to program a
slower movement, you must drive slowly to the stopping point.
c. You may drive up or down to any stopping point until it is entered.
Enter the point by pressing STM. Note: Stopping point will only be
recorded when the sledge is completely stationary. To be quite sure
of correct entry of any point, always wait a moment before pressing
STM.
d. Move to the second stopping point and enter it by pressing STM. Any
of up to 255 stopping points are entered by always pressing STM.
e. Before recalling or resetting the program in sequence, move to the starting point by
pressing GRF. The sledge automatically returns to this point at the maximum speed
chosen with the speed selector.
f. To recall the program, press A (Action) for every movement in chronological order.
A
Action
STF
STore First Flag
STM
STore Movement
GRF
Go to Reference Flag
