128-9105
6 of 20
Page 6
If the chirps were off before you started, then you will hear one chirp indicating they have been
turned on.
NOTE:
Whenever the chirps are bypassed, the 4-chirp intrusion indicator and 3 chirp
defective zone indicator will always operate. Since these are important warnings to you
that something has happened, they cannot be eliminated.
NOTE:
Your system must be programmed by the installation center to enable this feature.
RF SHOCK SENSOR MODE SELECTION
The way in which your alarm system reacts to threatening vibrations, created by attempts to
enter the vehicle by breaking a window, is adjustable by the transmitter immediately after arming.
There are 4 modes of operation that can be selected by the operator:
1. Normal Operation (default mode) In this mode, any strong vibrations will cause the siren
to sound (full detect) for 30 seconds. Any lesser vibration will cause the siren to emit 6
short warn away chirps, (pre-detect).
2. Stage 1 (Omit pre-detect) In this mode, the warn away chirps created by the lesser vibration
will be deleted. If strong vibration occurs, the siren will sound.
3. Stage 2 (Omit pre & full detect) In this mode, both the pre-detect stage and the full trigger
stage of the sensor are defeated. The unit will not react to vibration of any magnitude.
4. Stage 3 (City Mode) In this mode, the pre-detect chirps will change from six pre-warning
tones to a full 10 seconds of warning chirps. The full detect trigger duration will be reduced
from 30 seconds to 15 seconds.
NOTE:
Setting the stage of the shock sensor will be effective for one arming cycle only. Once
the system has been disarmed, the very next arming cycle will cause the sensor to
default to the normal operation stage.
To change or adjust the shock sensor, press and release the ARM button of you keychain
transmitter.
1. Within 2 seconds of arming, press and release the ARM button 1 time, to
defeat the pre-detect stage of the shock sensor. (The lights will flash and the
siren will chirp twice.)
2. Within 2 seconds of step 1, press and release the ARM button 2 times, to
defeat the pre and full detect stages of the shock sensor. (The lights will
flash and the siren will chirp three times.)
3. Within 2 seconds of step 1, press and release the ARM button 3 times to
enter the "City Mode" of operation. (The lights will flash and the siren will chirp four times.)
While under control of the remote starter, the system can be programmed to allow you to inhibit
the shock sensor by use of the transmitter. If the system has been programmed during
installation, simply press the lock button of your keychain transmitter anytime during the remote
start cycle. The shock sensor will be inhibited, for one run cycle and will resume normal
operation after the remote start unit shuts off.
Check with your installation center to determine if this feature has been programmed into your
system.
OPTIONAL DEVICE OUTPUT ( CHANNEL 3 )
Controlled By:
Trunk/Key Button
Other Transmitter button configurations are also available. Consult your installation center for
other configurations not listed above that may have been programmed to operate a specific
feature of your system.
This security system is equipped with an output which will activate when the appropriate
transmitter button is depressed for 3 seconds. Although this output is intended to activate the
trunk release option, any other optional devices may be connected to this channel. Consult
your installation center for more information about this output.
