30
IV. Maintenance
4.1 Regular Cleaning
■
Clean residuals
Some residual plastic may remain on the print bed. It can be removed with
tweezers (not included) or by wiping with a soft, dry cloth.
■
Clean the print head
After long use, some PLA plastic might stick to the surface of the print head.
This might affect future prints.
Preheat the print head and remove excess with tweezers.
Note: Be extremely cautious with the print head. It is extremely HOT!
■
Replace the extruder
If the extruder is jammed, please follow the steps below to replace:
1. Pull out the wire on the extruder.
2. Remove two screws on the top of the extruder.
3. Take the old extruder out.
4. Put a new extruder back inside the printer.
5. Screw in the two screws on top of the extruder.
6. Plug in the wire.
Note: Please do this when the print head is at room temperature.
Summary of Contents for I
Page 1: ...U S E R M A N U A L F U N E A S Y 3 D P R I N T I N G P a n o S p a c e I...
Page 2: ......
Page 6: ......
Page 35: ......
