15
4. From the slot on the back of the print bed, loosen the fastening screw under
point C with a M2.5 Allen wrench.
5. Click the “Go to C” button to point C.
6. Use the supplied adjustment tool to rotate the gear under the point C until
the gap is 0.4 mm. Then go back to the point A and fasten the fastening
screw.
7. Test the gap at the point A. If the gap changed, re-adjust step 3 to step 6.
8. Click the “Go to B” button and adjust the gap of point B, which is similar to the
steps of adjusting the point C.
9. Check the gaps under all three points. If gaps differ too much, redo above steps.
Summary of Contents for I
Page 1: ...U S E R M A N U A L F U N E A S Y 3 D P R I N T I N G P a n o S p a c e I...
Page 2: ......
Page 6: ......
Page 35: ......
