Pani BP2,5CT, User Manual

Page: 14 / 24

1 2 3 5 6 4
Stage Projector BP 2,5 CT Pani Projection and Lighting Vertriebs GmbH
6) Position Drawing Condenser System
Legend
Type: Order Code:
(1) HPAL Mirror 89/160 100-15-70
(2) HMI- Lamp 2500 W single ended H 1253 37202
(3) Meniscus Lens Ø 140 mm 222- 03- 02 (4)
Middle Condenser Lens PC Ø 220 mm/ R 157
(5) PANI – Universal Filter Ø 220 x 4
(6) Front Condenser Lens for Objective 11- 27 cm,
PC Ø 230 mm, multicoated, with Mounting Plate 12440
Front Condenser Lens for Objective 33- 40 cm,
PC Ø 230 mm, multicoated, with Mounting Plate 12441
Front Condenser Lens for Objective 50- 60cm,
PC Ø 230 mm, multicoated, with Mounting Plate 12442
Front Condenser Lens for Objective 80 -125 cm,
PC Ø 230 mm, multicoated, with Mounting Plate 12443
7) Electrical Connection
(See Electrical Schematic 222 – 15 - 35 )
The Stage Projector BP 2,5 CT is used in conjunction with the ballast BC 2500 W,
220/240V - 50Hz, Current 16 A (Order Code: D 1525). The ballast incorporates a
choke which limits lamp power to 25,6 A. Main power is interrupted when the
projector housing is opened.
7.1) Main Connection
BC 2500 W, 220/240V - 50Hz
Main Power Cable
3x2,5 square millimeters, two meters long with Schuko connector
(black). Phase R: brown, Neutral N: blue, Ground: yellow/green
Connected to power source 220VAC/50Hz. 16 A
7.2) Connecting Cable Ballast - Projector
Between the ballast and projector is a 3x4 square mm + 4x1 square mm in a single
cable. The standard length is 3 meters. This can be extended but must be tested if
extremely long runs are required. The connection is made with connector bodies at
both the ballast and projector end of the cable. The "ON" and the "OFF“ function
can be performed at either the ballast or the projector. Thus, it is possible to locate
the ballast away from the projector.
14