Stage Projector
BP 2,5 CT
Pani Projection and Lighting Vertriebs GmbH
4.3.1) Electrical Connection of the Slide Cooling Fan
The electrical connection of the slide cooling fan is accomplished with a 5- pole
connector, so that the fan housing can be removed from the projector both
mechanically and electrically. 2 contacts in this connector are wire in such a way that
when the connector is not plugged in the projector is shut down.
4.3.2) Mode Switch "Standard - Low Noise"
A "Standard - Low Noise" Mode switch is located on the slide cooling fan housing
(12) (operated with a small screwdriver).
ATTENTION:
Use "Low- Noise" Mode only
when silent operation is necessary, as cooling efficiency is reduced. Do not project
dark slides or slides with large dark regions in this case.
5) Operating Tips
5.1 ) HMI- Lamp
5.1.1) Lamp Installation and Replacement of the HMI- Lamp
For operation of the Projector a single ended HMI- Lamp 2500 W is required. Order
Code: 37202
a)
Disconnect the projector from the power source!
b)
Open the quick fastener (4) on the housing with a screw driver. Lift off the
housing cover (5) and set it aside. A built in safety switch prevents an accidental
operation of the unit when the housing is open.
c)
Lift out the reflector plate and reflector after removing the wing screw at the other
end of the distance bar.
d)
Insert and / or replace the lamp.
e)
Replace the reflector into the slot of the bottom distance rods and tighten wing
screw.
f)
Close the housing and lock the quick fastener.
ATTENTION:
Do not touch the quartz envelope of the lamp with your fingers during
installation. Finger prints can be burned in !
5.1.2) Lamp Adjustment
Three (3) adjustment screws are located on der underside of the Projector for
adjustment of the lamp.
Each projector is carefully adjusted at the factory (lamp base, reflector and
condenser). With the high precision manufacturing of halogen lamps, adjustment of
the lamp is rarely necessary. The HMI-lamp is supported at three points and can be
brought into the desired position from the outside on the lower part of the projector
with a three point adjustment. Proper adjustment of the lamp renders correct light
distribution and color reproduction and prevents improper imaging.
POSITION NUMBERS SEE PAGE 4
12
Summary of Contents for BP2,5CT
Page 1: ......
