© Panduit Corp. 2013
OPERATION MANUAL
PAT1M, PAT1.5M, PDM
ENGLISH
Page: 27 of 39
7H: Status Messages
Status messages are displayed as the dispenser performs self-diagnoses. No action is required on the part of the
operator other than notifying the maintenance department of the status message.
STATUS 1 - Calibrate line pressure sensor
Panduit
Calibrate line pressure sensor
STATUS 2 - Calibrate back pressure sensor
Panduit
Calibrate back pressure sensor
STATUS 3 - Reset EEPROM
Reset EEPROM
STATUS 4 - Reset dispenser RAM
Reset dispenser RAM
STATUS 5 - Reset tool RAM
Reset tool RAM
8: MAINTENANCE
8A: Daily Preventive Maintenance
The following maintenance of the PAT1M/PAT1.5M System must be performed daily (as needed) to ensure optimum
performance and trouble-free operation of the system.
INTERVAL
MAINTENANCE PROCEDURE
No more than 180 cycles
Empty tool tip collector before full.
(Refer to the
Tip Collector
section on Page 18.)
No more than 2500 cycles
(= ½ cable tie reel)
Empty dispenser carrier strip scrap bin.
(Refer to the
Reloading Procedure
section on Page 13.)
8B: Extended Maintenance
CAUTION: SAFETY GLASSES WITH SIDE SHIELDS MUST BE WORN AT ALL TIMES
DURING THE MAINTENANCE OR ADJUSTMENT OF THE PAT1M / PAT1.5M TOOLS.
CAUTION: ALWAYS DISCONNECT AIR SUPPLY FROM TOOL BEFORE DISASSEMBLY.
CAUTION: ELECTROSTATIC SENSITIVE DEVICE. DO NOT OPEN OR HANDLE EXCEPT AT
A STATIC FREE WORK STATION.
