13
12
USER MANUAL
PANDORA DXL 0110L CAR SERVICE-SECURITY SYSTEM
After correct input of PIN-code the system will enter programming mode, if
it was disarmed and the ignition was switched off.
For emergency arming when the engine is stopped, press and hold
VALET
button for 3 seconds. The system will be armed in 30 seconds.
Enabling/Disabling immobilizer radio tag
Write down or remember the «Service PIN-code»
To disable immobilizer radio tag, enter level 15 (the system should be in
programming mode). Enter the «Secret PIN-code» to disable radio tag or press
VALET
button once to enable radio tag.
Enter the «Service PIN-code» to enter programming mode (factory preset of
the service PIN-code is «1-1-1-1»). You can enter the code only if the base unit is
powered, the ignition is switched off, and the system is disarmed. If there is no
«Service PIN-code», you can enter programming mode using the «Secret PIN-
code» written on the owner’s card. After entering the programming mode, press
VALET
button 15 times (pauses between presses should not exceed 1 second).
The system will confirm entering the level with 15 sound signals of the Beeper.
Disabling radio tag:
The system will wait 10 seconds for entering the «Secret PIN-code». If
the PIN-code is not entered within 10 seconds, the system will return to
the programming menu. Enter the «Secret PIN-code» that is written on the
owner’s plastic card. The system will confirm disabling of the radio tag with
two sound signals of the siren and the series of the sound signals of the
Beeper. After that the system will return to the programming menu. Switch
on the ignition to exit programming mode.
Enabling radio tag:
The Beeper will emit a long sound signal after entering the level. The system
will wait for action. Press
VALET
button once to enable radio tag. The system
will confirm enabling with one short sound signal of the siren/Beeper. After
that the system will return to the programming menu. Switch on the ignition
to exit programming mode.
SYSTEM INSTALLATION
General installation requirements
• Install base unit only inside car interior.
• Install securely each system’s component, as conditions of the car
standard operation can harm functionality of the alarm system and cause
damage to the car original systems, including the elements of safety in motion.
• The system installation should be performed when the system sockets
and the negative battery terminal are disconnected.
• The base unit power supply should be switched off when connecting to
CAN-bus.
• The system installation can be performed via twisting together or via
lead-tin soldering followed by isolation of a switching place.
• When wiring, pay attention to sections and materials of switched
conductors, if they are different, bring electrochemical potentials to the
minimal difference. The isolation should not allow for moisture to reach wiring,
as the presence of moisture will increase electrochemical destruction of wires
(this is especially important for the large current circuits).
• Switched connections should be placed as high as it is possible in the
cavities so water condensate will not form drops on the switching location.
• To avoid the destruction of compounds by car vibration, ensure that
there is a bit of free length to the wiring, providing enough sagging.
• Do not allow wiring in places where the wires isolation can be destroyed
by abrasion.
• Electronic system units should be placed sockets down and as high as
possible to avoid condensate reaching electronic components through the socket.
• When installing base unit, secure it to the car body for correct operation
of in-built shock sensor.
• All unused system wires during the installation must be insulated and
secured to prevent accidental touching of a car body or other wires.
WARNING!
IT IS HIGHLY RECOMENDED TO CHANGE FACTORY
PRESET OF THE «SERVICE PIN-CODE» FOR IMPROVING
SECURITY OF THE SYSTEM