19
18
USER MANUAL
PANDORA DXL 0110L CAR SERVICE-SECURITY SYSTEM
INSTALLATION AND CONFIGURATION OF THE SYSTEM
Entering the programming menu, entering PIN-code
To change the system settings or program the system using a computer
or
VALET
button, the system should be in programming mode. Enter
programming mode by entering «Service PIN-code» (factory preset is 1-1-1-1).
PIN-code should be entered using external or located on the base unit
VALET
button. The input is indicated by the sounds of the Beeper or by flashes of the
LED
indicator located on the base unit. You can enter the code only if the base
unit is powered form USB socket or from external power supply, the ignition is
switched off and the system is disarmed.
Entering PIN-code:
• Enter the first digit of the code using
VALET
button. Press the button
a number of times, equal to the first digit. Pauses between presses should
not exceed 1 second, each pressing will confirm with orange
LED
indicator
flash. Pause for more than 1 second and red
LED
indicator with a short
sound signal of the Beeper confirm the input of the first digit. Then you can
enter the next digit.
• Enter the second and third digit of the code using
VALET
button in the
same way.
• Enter the fourth digit of the code using
VALET
button. The system will
confirm correct PIN-code with red and green flashes of
LED
indicator with
multiple sound signals of the Beeper and the system will enter programming
mode. If the input was incorrect, it will be indicated with long red flash and a
short sound signal of the Beeper. New input can be attempted after 5 seconds.
Exit programming mode:
To exit programming mode turn on the ignition or turn off power of the base
unit. The system will reboot programmatically (all changes will be saved) after
exiting programming mode using ignition. All ways to exit the programming
menu are accompanied by sound signals of the siren/Beeper and light signals
of the LED indicator. Light signals indicate the number of registered devices:
first green flashes indicate the number of registered radio tags, red flash
indicates registered mobile device.
Status indicator lights during PIN-code entering:
Short orange flash
Confirmation of VALET button pressing
Short red flash
Confirmation of entering a PIN-code digit
Red and green flashes
Entered PIN-code is correct
Long red flash
Entered PIN-code is incorrect
Preparing to program the system using a computer
The system allows programming all settings and updating software of the base
unit via micro-USB cable. If base unit has not yet been installed in the vehicle,
it will be powered via micro-USB cable while programming. To program using
a computer, you need a standard USB cable, a computer with Windows XP/
Vista/7/8/10 and Pandora AlarmStudio application (you can download it from
pandorainfo.com).
In preparation to the programming these stages should be followed:
• connect the system and PC via USB cable;
• start Pandora AlarmStudio;
• enter the programming settings mode by entering the service PIN-code.
Updating firmware
It is recommended to update firmware of the base unit before installing and
programming the system (actual vesion of the firmware you can download
from
pandorainfo.com
). You can update firmware using AlarmStudio
application after entering programming mode or using quick boot algorithm
(PIN-code is not required).
Quick boot mode: open AlarmStudio; de-energize and disconnect the
system; press and hold
VALET
button located on the base unit; release the
button immediately after connecting the system and a computer via USB
cable; the system will enter boot mode.
If the boot mode has been interrupted for some reason and the status
indicator lights red, you need to load firmware using quick boot mode (without
entering PIN-code).