Pando P-842, Installation Manual

Page: 6 / 28

INOXPAN S.L. EN
The symbol on the product or its packaging indicates that this product cannot be
disposed of like normal domestic waste. The product must be handed over at a
collection point for recycling electrical and electronic equipment. If you ensure
that this product is correctly disposed of, you will help to avoid the possible
negative environmental and public health effects that could arise from incorrect
disposal. For more detailed information about recycling this product, please
contact your city authorities, the domestic waste service or the establishment
where you purchased it. This electrical appliance is marked in compliance with
European Directive 2002/96/EC on electrical and electronic appliance waste
(WEEE).
Firstly, we would like to thank you for your confidence in our firm when you chose a Pando extractor
hood.
Read carefully the safety instructions indicated in the use and installation manual enclosed in the
accessories and product documentation bag.
Installation should only be carried out by qualified professionals, professional installers or
the official technical service.
VERY IMPORTANT!
When opening the packaging, check that all the components are in perfect state and all the
accessories are present. If this is not the case, contact the dealer and do not install. Once installed,
any damage to the exterior such as scratches, dents, stains, etc. will not be covered by the
guarantee.
DO NOT REMOVE THE PROTECTIVE PLASTIC FROM THE HOOD UNTIL IT IS COMPLETELY
INSTALLED, IF THIS PLASTIC IS NOT PRESENT IN AREAS THAT COULD HAVE A RISK OF
DAMAGE DURING INSTALLATION, IT IS RECOMMENDED TO APPLY PROTECTIVE
MATERIALS AGAINST IMPACT, SCRATCHES AND CONTACT WITH CORROSIVE AGENTS.
TAKE ESPECIAL CARE DURING THE INSTALLATION IF OTHER WORK IS ALSO IN
PROGRESS, BECAUSE PAINT, SILICON, PLASTER AND OTHER MATERIALS COULD
CONTAIN CORROSIVE CHEMICALS THAT MAY DAMAGE THE PRODUCT, IN THESE CASES
IT IS RECOMMENDED TO ADEQUATELY PROTECT THE HOOD, BY FOR EXAMPLE,
HERMETICALLY COVERING AREAS THAT COULD BE AFFECTED WITH PLASTIC.
THIS WILL AVOID DAMAGE TO THE OUTSIDE OF THE APPLIANCE, SOMETHING THAT WILL
NOT BE COVERED BY THE GUARANTEE.
It must be taken into account and provide that the hood and peripherals must have easy and safe
access for possible maintenance or repair tasks of the official Pando technical service (SAT).
The guarantee will NOT cover the costs and means necessary for access to a product that does
not meet these conditions. In the event that the product is not easily accessible or safe, a
criterion that will be issued by SAT in its initial inspection, it will be the responsibility of the client
to place the means and assume the necessary costs so that the SAT can perform the intervention
adequately.
EN - INTRODUCTION
EN - SAFETY INSTRUCTIONS
6