P
a
n
chromatic
Eumig P 25
User Manual
Rewinding
First place knob
21
(fig.A) into the “still” position.
Disconnect belt of upper spool arm and place on
the inner groove of the double pulley
10
(fig.B).
Remove the belt from the lower spool arm. The
projector is switched for forward motion. Remove
the shorting plug / resistance, which disconnects
the lamp, and lead the film from the lower to the
upper, empty reel. Switch on and regulate the
speed of rewind exactly as projecting.
Maintenance
The projector and especially the parts in contact with
the film, must be kept scrupulously clean. To facilitate
cleaning, the entire gate mechanism may be withdrawn
by opening lever
5
(fig.A), but before doing so, care
must be taken to turn the main driving wheel
8
(fig.B )
until the dot marked on the same is on the top. In this
position the claws are withdrawn and cannot be dam-
aged. Now, press the gate closed with the fingers and
gently ease the unit forward and out without using any
undue pressure. The film gate as well as the lens, the
condenser and the reflector should be cleaned with a
very soft cloth or brush. For removing the lens, press
away spring
3
(fig.A), which will then allow removal of
the lens. Oiling of the projector should be done regular-
ly after projection or every 3000 ft. of film or so. Interi-
or bearings are lubricated from the central point
6
(fig.B). (After removing the closing button.) External
points to lubricated are indicated by red spots. Cleaning
and oiling of the claw mechanism is easier if the film
gate is removed. The little spring is pressed down on
the spot marked by number 7 (fig.A) and the entire lens
