Panasonic YD-350GY4, Operating Instructions Manual

Page: 30 / 55

Operation
27
9 Operation
Depending on the CHANGE button settings and the use of “Crater repeat”, torch operation varies as follows.
Note
：
After turning on the torch switch, if the voltage detect is not executed, the welder goes in an error state (Err6: Arc
start error) and turns off the output automatically.
9.1 Welding current calibration
Welding current is tested and calibrated with following welding wire extension. it may need read justment with
moved welding parameters such as torch angle, wire type, shieling gas and other welding conditions.
Welding current 50A 100A 150A 200A 250A 300A 350A
Extended wire length (Tip-Base
metal distance)
0.9
㎜
wire
0.8
㎜
wire
12 12 12 15 18
－ －
1.2
㎜
wire
1.0
㎜
wire
15 15 15 18 18 22 25
9.2
“
NO CRATER”
Operation: Turn the torch switch on and off to start and stop welding arc respectively.