![background image](http://html1.mh-extra.com/html/panasonic/wv-sw598apj/wv-sw598apj_operating-instructions-manual_4719031207.webp)
[Reset to the default and load the default HTML files.]
Click the [Execute] button to reset the settings of the camera and the HTML files to the default. Note that the
network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reboot]
Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutes
after rebooting the camera.
[Position refresh]
The camera position can be refreshed. When the camera has moved from the correct home/preset position
during normal use, or when it has been inadvertently moved while turning on the power of the camera, use
this function to correct the camera position.
It is impossible to operate the camera during the position refresh process (for about 2 minutes).
IMPORTANT
•
The direction of the camera may be accidentally changed when the camera is installed. When
registering presets after the installation, we recommend performing position refresh.
Note
•
The notification function allows users to notify errors to the destinations specified in “E-mail
notification” - “Destination E-mail address” and “Panasonic alarm protocol notification” - “Destination
server address” in the [Notification] tab on the “Alarm” page when an error occurs such as having no
SD memory card inserted after rebooting or inserting a locked SD memory card. (
®
•
SW598A
SW397B
:
To initialize the network settings (
®
page 166), turn off the power of the camera, then turn on the power
again after turning the INITIAL SET switch to ON. The camera will start up after about 6 minutes, and
the settings including the network settings will be initialized. Do not turn off the power during
initialization. Once initialization is completed, turn off the power and then turn the INITIAL SET switch
to OFF.
SC588A
SC387A
:
To initialize the network settings (
®
page 166), turn off the power of the camera, then turn on the power
again while holding down the INITIAL SET button on the unit, and keep the INITIAL SET button held
down for about 5 seconds. Wait about 6 minutes after releasing the button. The camera will start up
and the settings including the network settings will be initialized. Do not turn off the power of the unit
for about 6 minutes after turning on the power.
Operating Instructions
207
19 Maintenance of the camera [Maintenance]