21
2
Connect an external amplifier-embedded speaker to the audio output cable.
Connect a stereo mini plug (ø3.5 mm) (Audio output is monaural.).
• Output impedance: Approx. 600 Ω (unbalanced)
• Recommended cable length: Less than 10 m {32.8 ft}
• Output level: –20 dBV
* Use an external powered speaker.
IMPORTANT:
• Connect/disconnect the audio cables and turn on the power of the camera after turning off the
power of the audio output devices. Otherwise, loud noise may be heard from the speaker.
• Make sure that the stereo mini plug is connected to this cable. When a monaural mini plug is
connected, audio may not be heard.
When connecting a monaural speaker with amplifier, use a locally procured conversion cable
(mono-stereo).
3
Connect the alarm input/output cable.
4P alarm cable
GND (black)
ALARM IN3, AUX OUT (gray) (Terminal 3)
ALARM IN2, ALARM OUT (red) (Terminal 2)
ALARM IN1, DAY/NIGHT IN (green) (Terminal 1)
<Ratings>
• ALARM IN1(DAY/NIGHT IN), ALARM IN2, ALARM IN3
Input specification:
No-voltage make contact input (4 V - 5 V DC, internally pulled up)
OFF:
Open or 4 V - 5 V DC
ON:
Make contact with GND (required drive current: 1 mA or more)
• ALARM OUT, AUX OUT
Output specification: Open collector output (maximum applied voltage: 20 V DC)
Open:
4 V - 5 V DC by internal pull-up
Close:
Output voltage 1 V DC or less (maximum drive current: 50 mA)
* The default of EXT I/O terminals is “Off”.
IMPORTANT:
• Be sure to use the 4P alarm cable provided with this product.
• Off, input, and output of the external I/O terminal 2 and 3 can be switched by configuring the
setting. Refer to the Operating Instructions on the provided CD-ROM for further information
about the EXT I/O terminal 2 and 3 (ALARM IN2, 3) settings (“Off”, “Alarm input”, “Alarm out-
put” or “AUX output”).
• When using the EXT I/O terminals as the output terminals, ensure they do not cause signal col-
lision with external signals.
• Install external devices so that they do not exceed the ratings above.
