22
4
Connect a LAN cable (category 5 or better, straight, STP: For Europe) to the network connector.
IMPORTANT:
• Use all 4 pairs (8 pins) of the LAN cable (category 5 or better, straight, STP: For Europe).
• The maximum cable length is 100 m {328 feet}.
• Make sure that the PoE device in use is compliant with IEEE802.3af standard.
• When connecting both the 12 V DC power supply and the PoE device for power supply, 12 V
DC will be used for power supply*.
* If a 12 V DC power supply and a PoE hub or router are used at the same time, network con-
nections may not be possible. In this case, disable the PoE settings.
Refer to the operating instructions of the PoE hub or router in use.
* In the situation where a 12 V DC power supply and a PoE hub or router are used at the same
time and the 12 V DC power supply is then disconnected, the power supply may be stopped
and the camera may restart depending on the PoE hub or router used.
• When the LAN cable is disconnected once, reconnect the cable after around 2 seconds. When
the cable is quickly reconnected, the power may not be supplied from the PoE device.
• When cables are used outdoors, there is a chance that they may be affected by lightning. In
this case, install a lightning arrester just before where the cables connect to the camera.
5
Connect the power cable.
Caution:
• A READILY ACCESSIBLE DISCONNECT DEVICE SHALL BE
INCORPORATED TO THE EQUIPMENT POWERED BY 12 V DC
POWER SUPPLY.
Connect the output cable of the AC adapter to the 2P power cable.
IMPORTANT:
• The 12 V DC power supply shall be insulated from the commercial AC power.
• Be sure to use the 2P power cable provided with this product.
• Be sure to fully insert the 2P power cable into the 12 V DC power supply terminal. Otherwise, it
may damage the camera or cause malfunction.
• When installing the camera, make sure that excessive force is not applied to the power cable.
Power cable
12 V DC
Red
Positive
Black
Negative
