15
Precautions for installation
Power supply
This product has no power switch.
When turning off the power, turn off a power
supply or remove a power cable. When the
power cable of the product is connected to the
power supply device, the power will be sup-
plied to the product.
Before cleaning the product, make sure that
the power cable is not connected to the main
power supply.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong wall or ceiling) in your
particular environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
SF V 631L
SF V 611L
This product is designed to be installed
under eaves.
• Install the product in areas that do not
receive direct sunlight.
• When the product is installed outside in
areas that receive direct sunlight, such as
on external walls, use the optional
"Extended Sun Shade WV-Q7118".
SF R 631L
SF R 611L
SF N 631L
SF N 611L
This camera is designed to be used
indoors.
This product is not operable outdoors.
Do not expose this camera to direct sunlight
for hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion. Keep this camera away from water and
moisture.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations where corrosive gas is pro-
duced, locations where it may be dam-
aged by briny air such as seashores
• Locations where the temperature is not
within the specified range (
☞
page 21)
• Locations subject to vibrations, such as on
vehicles, marine vessels, or above product
lines (This product is not designed for on-
vehicle use.)
Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
For information about the installation tasks, refer to the provided Installation Guide.
