Maintenance
3-31
Position
Adjustment
Attention:
The CCD unit should be adjusted
ONLY WHEN the printer fails to
adjust it.
Image skew adjustment
Before loosening the CCD fixing screw
(front), put a mark on the position where
the CCD is installed.
Loosen only the CCD fixing screw (front).
When the image skew is shown left
(Figure 1), turn the screw (front) clockwise.
When the image skew is shown left
(Figure 2), turn the screw (front)
counterclockwise.
3. Skew/Lead edge position adjustment (Scanner unit)
1
2
3
4
(Original)
Figre 1 (Copy)
Figre 2 (Copy)
Position
Procedure
Make copies with Test chart 53.
Adjust the lead edge with "
F6-C07
".
(+) : Increase the void.
(–) : Decrease the void.
Adjust the rear end void with "
F6-08
".
(+) : Increase the void.
(–) : Decrease the void.
4. Void Registration adjustment
1
2
3
Summary of Contents for WORKIO DP-150
