5. Press the F1 button.
The WJ-RT416 Series SETUP MENU will appear on the
active monitor, and "
B
" mark will light up beside "On".
The following functions and buttons are valid in SETUP
MENU.
<Main unit>
JogDial clockwise:
Increases a parameter.
JogDial counterclockwise:
Decreases a parameter.
CAM (SET) button:
Executes the selections and dis-
plays a submenu.
+ button:
Increases a parameter.
– button:
Decreases a parameter.
MON (ESC) button:
Returns to the SETUP MENU or the
previous menu.
<3D joystick unit>
3D joystick upward (
D
):
Moves the cursor up.
3D joystick downward (
C
):
Moves the cursor down.
3D joystick to the left (
A
):
Moves the cursor to the left.
3D joystick to the right (
B
):
Moves the cursor to the
right.
WJ-RT416 SERIES CONTROL (WJ-CU950/650 TERMINAL MODE)
The matrix switcher can control the following function of the
Digital Disk Recorder WJ-RT416 Series. The following is the
procedure for the WJ-RT416 Series SETUP MENU:
Notes:
• The following operating procedures are for the terminal
mode. If you are using a PS.Data system controller,
refer to page 6.
• When a Multiplexer board is installed in the matrix
switcher, you can neither connect nor control a WJ-
RT416 Series recorder. You need to remove the board
from the matrix switcher.
• Some parts of monitor displays described in this docu-
ment may differ from the actual parts.
■
Displaying WJ-RT416 Series
SETUP MENU
To display the WJ-RT416 Series SETUP MENU, follow the
procedure below:
1. Confirm that the WJ-RT416 Series is correctly and
securely connected.
2. Select the desired monitor.
3. Activate the recorder mode.Then, the selected monitor
number, recorder number, and "/HD300" will appear on
the LCD.
4. Press the MENU button repeatedly until "System Setup"
appears on the LCD.
Mon4 Cam-- R4
/HD300
System Setup 301
5
On Off
System Setup 301
On Off
4
600 RECORDER
CONTROL ADR EXT IN
610 MASTER ---
620 SLAVE1 HD300 01 GENLOCK OFF
630 SLAVE2 HD300 01 GENLOCK OFF
640 SLAVE3 HD100 01
650 SLAVE4 OFF GENLOCK OFF
--COMMUNICATION STATUS--
DATA BIT 7bit
PARITY BIT ODD
STOP BIT 1bit
BAUD RATE 9600bps
COMM PORT SERIAL PORT
If the firmware of this unit is Ver. 2.03 or later,
select "HD300" for "CONTROL" in 600 RECORDER of
SETUP MENU (OSD).