13
Detect cameras for registration [Detect cameras]
Clicking the [Setup >] button of "Detect cameras" on the [Camera registration] tab will display the following window.
After editing the settings, click the [OK] button to save the settings and return to the [Camera registration] tab.
Note:
• Before the settings, register the cameras into the
network. Even though it is possible to detect up to
192 cameras, only 64 cameras can be registered.
[Port selection]
Select the port to which the camera to be detected is
connected.
[New] button
Deletes all the current settings and searches all the
connected cameras. The models, results of the
detected cameras and IP addresses will be displayed.
[Addition] button
Detects only the added or replaced cameras. The
models, results of the detected cameras and IP
addresses will be displayed.
[No.]
Shows a number of detected cameras in order of the
IP address. The maximum number of detectable
cameras will be 192 units.
[Select]
Mark the checkboxes of cameras to register.
The vacant number will be fulfilled by the subsequent
camera.
[Model]
When Panasonic cameras are used, the model num-
bers will be displayed.
[Results]
New: Displayed when the camera is newly connected
to the recorder.
Replaced: Displayed when the camera has been
replaced by another one.
Added: Displayed when the camera connection is
added to the recorder.
Registered: Displayed when the camera has already
been registered.
Lost: Displayed when the registered camera is not
detected.
Blank: No camera is detected.
[IP address]
Displays the IP addresses configured for the detected
cameras.
[Auto addressing]
The IP addresses of the cameras whose checkboxes
are marked will be automatically configured.
[Start IP address]
Specify the start IP address and order when setting
the IP address automatically.
Note:
• It is impossible to register cameras in other networks
via the same router.
• For the security enhancement, changing of the IP
address of the camera will become impossible
when 20 minutes have passed after the power is
turned on. Refer to the operating instructions of
the camera for further information.
• When "On" is selected for the "DHCP" setting of
the detected cameras, the recorder will forcibly
change the setting to "Off" to give the IP
addresses automatically.
• If the IP address of the camera is set to be
assigned automatically, an IP address will be
assigned to the camera when the [OK] button is
clicked. In this case, the default gateway (
☞
Page
51) of the recorder is set to the default gateway
of the camera.
• Click the [Cancel] button to return to the [Camera
registration] tab without applying the camera
detection result.
[Setup via recorder's main monitor]
