8
5.Replacement Guide
INSTALLATION
3. Fix the switch box by 1 screw (ST4.2X8) from
accessories. (Fig.3)
2. Take off the ballast assembly by removing 3 screws
(ST4.2X12). (Fig.2)
4. Take out the light lead wire assembly A from
accessories, and connect to junction box. Then
fix the light lead wire assembly by 3 screws (ST4.2X12),
and 3 cord clips(5N,from accessories).(Fig.4)
1. Remove the primary light kit grille by pulling down
one mounting spring,
and remove
plug connector
Ⅰ
,then pull down the other mounting
spring (Squeeze mounting spring and pull down
carefully) (Fig.1)
remove sensor unit
.
Keep the screws that are removed for
following use.
Ceiling
Grille
sensor unit
Gloves
Rib
Claw
Ballast Assembly
Switch box
Switch box
Lighting unit
Plug connector
Mounting spring
Fig.4
Fig.5
For models of FV-08VKML3,
FV-13VKML3 only. Only fix
the sensor lead wire.
Fig.1
Light lead wire assembly A
Screw(ST4.2X8)
3 screws(ST4.2X12)
Fig.2
Fig.3
3 screws(ST4.2X12),3 cord clips(5N)
Disconnect power source before working
on unit.
WARNING
Remove the tapes from grille and springs
before installation new light kit grille as below
5.Take out the new light kit grille.Remove screw(M4X8).
Remove light kit cover assembly. (Fig.5)
CAUTION
Tapes
IMPORTANT:
Light kit cover
assembly
Remove screw
(M4X8)