Panasonic WH-UD28AE, Service Manual

Page: 27 / 82

27
• Secure the cable onto the control board with the holder
(clamper).
2. Cable connection to the power supply through isolating
device (Disconnecting means).
• Connect the approved polychloroprene sheathed power
supply cable (3 x 4.0 mm
2
), type designation 60245 IEC
57 or heavier cord to the terminal board, and connect the
other end of the cable to isolating device (Disconnecting
means).
3. To avoid cable harmed by sharp edge, cables must go
through bushing (located at the bottom of indoor unit)
before carry out electrical connection. The bushing must
be used and must not take off.
11.3.4.1. Wire Stripping and Connecting
Requirement
Terminal screw Tightening torque N
O
cm {kgf
O
cm}
M3 69~98 {7~10}
M4 157~196 {16~20}
M5 196~245 {20~25}