9
Item
Unit
Indoor Unit
Performance Test Condition
EN 14511
Outdoor Ambient
°C
Cooling: 16 ~ 43
Heating: -20 ~ 35
Operation Range
Water Outlet
°C
Cooling: 5 ~ 20
Heating: 20 ~ 55
Internal Pressure Differential
kPa
Cooling: 19
Heating: 30
Condition
(Ambient/Water)
A35W7 A7W35 A2W35
dB (A)
Cooling: 33
Heating: 33
—
Noise Level
Power Level dB
Cooling: 46
Heating: 46
—
Height
mm (inch)
892 (35-1/8)
Width
mm (inch)
500 (19-11/16)
Dimension
Depth
mm (inch)
340 (13-13/32)
Net Weight
kg (lbs)
43 (95)
Liquid
mm (inch)
9.52 (3/8)
Refrigerant Pipe Diameter
Gas
mm (inch)
15.88 (5/8)
Inlet
mm (inch)
28 (1-3/32)
Water Pipe Diameter
Outlet
mm (inch)
28 (1-3/32)
Water Drain Hose Inner Diameter
mm (inch)
15 (19/32)
Motor Type
DC Motor
No. of Speed
7 (Software Selection)
Pump
Input Power
W
58
Type
Brazed
Plate
No. of Plates
36
Size (W × H × L)
mm
65 × 120 × 376
Hot Water Coil
Water Flow Rate
l/min (m
3
/h)
Cooling: 20.1 (1.2)
Heating: 25.8 (1.5)
Pressure Relief Valve Water Circuit
kPa
Open: 300, Close: 266 and below
Flow Switch
Electronic Sensor
Protection Device
A
Residual Current Circuit Breaker (25)
Volume I
10
Expansion Vessel
MWP bar
3
Capacity of Integrated Electric Heater
kW
3.00
Note:
Cooling capacities are based on outdoor air temperature of 35°C Dry Bulb with controlled indoor water inlet
temperature of 12°C and water outlet temperature of 7°C.
Heating capacities are based on outdoor air temperature of 7°C Dry Bulb (44.6°F Dry Bulb), 6°C Wet Bulb
(42.8°F Wet Bulb) with controlled indoor water inlet temperature of 30°C and water outlet temperature of 35°C.
Specification are subjected to change without prior notice for further improvement.
Flow rate indicated are based on nominal capacity adjustment of leaving water temperature (LWT) 35°C and
∆
T
= 5°C.
