2
For your safety
To prevent severe injury and loss of life/
property, read this section carefully
before using the product to ensure proper
and safe operation of your product.
Preventing fire, electric shock and
short circuits
R
Leave installation work to the
dealer. Installation work requires
technique and experiences. Failure
to observe this may cause fire,
electric shock, injury, or damage to
the product. Consult the dealer.
R
Electrical connection work should
be performed by certified
personnel only. Certification is
required for performing electrical
connection work. Consult your
dealer.
R
Do not attempt to disassemble or
modify this product. Contact an
authorised service centre for repairs.
R
Never install wiring during a lightning
storm.
R
Do not connect non-specified devices.
R
Do not connect a power cable to a
terminal that is not specified in this
guide.
R
When opening holes in walls for
installation or wiring, or when securing
the power cable, make sure you do not
damage existing wiring and ductwork.
R
Do not make any wiring connections
when the power supply is turned on.
R
Do not install the main monitor in the
following places:
– Places where the main monitor may
be splashed with water or chemicals.
– Places where there is a high
concentration of dust, or high
humidity.
R
Do not place objects on the power
cables. Install the product where no
one can step or trip on the power
cables.
R
Do not allow the power cables to be
excessively pulled, bent or placed
under heavy objects.
R
When existing wires are used, it is
possible that they contain AC voltage.
Contact an authorised service centre.
Preventing electric shock
R
If the wiring is underground, do not
make any connections underground.
R
If the wiring is underground, use a
protection tube.
R
If the wiring is outdoors, use a
protection tube or a surge protector.
Preventing injury
R
Install the product securely adhering
to the instructions in this guide to
prevent it from falling off the wall.
Avoid installing onto low-strength
walls, such as gypsum board, ALC
(autoclaved lightweight concrete),
concrete block, or veneer (less than
18 mm thick) walls.
R
To prevent serious injuries due to the
product unexpectedly falling, the
product with a wall mount feature must
be installed at a height of 2 m or lower.
WARNING
CAUTION
