9
Installing the doorphone
Important:
R
On the bottom surface of the doorphone and the
mounting base, there are holes to allow water to
drain. Do not cover them up when installing.
R
When existing wiring (such as chime wires) is
used:
– It may contain AC voltage that may cause
electric shock and/or damage the product.
– Never use the following types of wiring.
Consult a qualified technician/dealer.
R
See "Wire type and length" for information about
wiring materials.
1
Remove the mounting base.
A
Open the screw cover (
A
).
B
Screwdriver
B
Loosen the mounting screw (
C
).
D
Water drain holes
E
Mounting base
2
Attach the mounting base (
A
) to the wall
securely using the wood screws (
B
)
(accessory).
R
Install the mounting base on a vertical flat
wall.
R
Before drilling, refer to “Precautions for
installation” for installation location.
C
Wire (locally procured)
D
83.5 mm
*1 To prevent dew condensation, fill a hole
for wiring as much as possible.
3
Adjust the camera angle using the camera
angle control lever.
A
Camera angle control lever
B
Left (maximum 15°)
C
Right (maximum 15°)
D
Upwards (maximum 15°)
A
B
C
D
E
A
B
C
D
*1
A
B
C
D
Rear view
prj_6905-en_gb.book Page 9 Monday, April 24, 2017 6:10 PM
