V
iewing 3D images
●
Basic
31
3D Eyewear
3D Eyewear set (2)
TY-EW3D10E
●
3D Eyewear
Support band
BK103839
●
Nose pad A
NPA103821
●
Nose pad B
NPA103834
●
3D Eyewear case
Use either nose pad A or B for your preference.
●
3D Eyewear can be worn over vision correction glasses.
●
Part names and functions
■
Infrared receiver
Receives infrared signals from the TV.
3D Eyewear is controlled by receiving infrared signals from the TV,
●
which allows you to view 3D images.
Note
Do not soil the infrared receiver section or attach stickers etc. to it.
●
Battery cover
When using for the first time, remove the insulating sheet.
●
Insulating sheet
Pull the insulating sheet
To replace the battery
●
“Replacing the battery” (p. 32)
Support band attaching parts
If required, attach the support band.
To attach the band
●
“Attaching the support band” (p. 32)
Lenses - Liquid Crystal Shutter
Controls the images for 3D viewing.
The left and right liquid crystal
●
shutters are alternately opened and
closed in time with the images on the
TV screen to achieve the 3D effect.
Note
Do not apply pressure to or scratch
●
the surface of the liquid crystal
shutter.
Power button of the 3D Eyewear
(bottom side of the 3D Eyewear)
Switches the the 3D Eyewear on or off.
Press the button for about 1 second to turn the power on. The
●
power lamp lights for about 2 seconds and then goes off.
To turn the power off, press the button for about 1 second again.
●
The power lamp flashes 3 times, then the 3D Eyewear turns off.
Power button
Power lamp
Note
If the 3D Eyewear does not receive any signals from the TV for
●
about 5 minutes, the 3D Eyewear will be turned off automatically.
Nose pad installation section
If required, attach the nose pad.
To attach the nose pad
●
“Attaching the nose pad” (p. 32)