18. Removal of Eye Cap
Remove the Eye Cap after removing the 2 Screws (533).
19. Handling cautions of EVF Lens Unit
Use extreme care when handling the EVF Lens Unit to
avoid damage, dust, and spots (especially fingerprints,
etc.)
Installation of EVF Lens Unit, Eye Sight Lever
1) Install the Eye Sight Lever into the EVF Case hole in the
direction shown.
2) Install the EVF Lens Unit into the EVF Case.
3) After installing, verify the Eye Sight Lever and the EVF
Lens Unit work together correctly.
EVF Lens
Unit
Eye Sight Lever
Hole
EVF Case
Rotate
Fig. D17
17. Installation of EVF F.P.C., EVF Lock Plate, EVF Slide
Base and Shoe Angle
Take care not to damage the F.P.C. and the Switch.
1) Insert the EVF F.P.C. into the slot and secure it with the
2 pins. Then, pass it through the hole.
2) Install the EVF Lock Plate with the Locking Tab (L-2).
3) Connect the EVF F.P.C. to Connector FP8901, and
install the EVF Slide Base so that the ribs are inserted
into the slots.
4) Install the Shoe Angle with the 2 pins. Then, tighten the
Screw (533).
5) After installing, verify the EVF moves correctly.
<Bottom View>
Pins
533
EVF Standby
Switch
Pass
FP8901
Rib
Slot
Pin
Pin
Ribs
(L-2)
Pin
Slot
Hole
EVF Slide Base
Shoe Angle
Pin
Pin
Pin
Pin
Pin
EVF Lock Plate
EVF F.P.C.
Fig. D16
35
Summary of Contents for VDR-D220E
