7
SPECIAL REMARKS
‘‘DRY’’ Operation
•
Once the room temperature reaches the level that was set, the unit repeats the cycle of
turning on and off automatically.
•
In order to prevent the humidity in the room from rising again, the indoor fan also turns off
when the unit stops operating.
•
The fan speed is set to ‘‘LO.’’ automatically, and cannot be adjusted.
•
‘‘DRY’’ operation is not possible if the outdoor temperature is 59°F (15°C) or less.
Heating Performance
•
Since this air conditioner utilizes outside air for heating, its heating performance
deteriorates as outside temperature decreases. (Due to heat pump system)
•
It will take some time until the room becomes warmer after heating operation started. (Due
to hot air circulation system in order to heat a whole room)
Defrosting
•
This appliance may start defrosting operation to melt frost form in the outdoor unit during
long hour heating operation mode.
The indoor unit fan will stop for about 5 to 10 minutes at this time.
Heating Standby
The remote controller shows “
” (Heating standby) on the display in the following mode and
the indoor unit fan may be controlled.
•
When operation started (Indoor unit fan stops for maximum 6 minutes.)
•
When Thermostat activated
•
When defrosting (Indoor unit fan stops.)
Remote Control Sensor
The temperature sensor in the indoor unit normally senses the room temperature and can also
sense the ambient temperature of the remote controller.
For the details, consult the shop you purchased.
Should the power failure
occurs while the
unit is running
When the unit automatically resumes operation after temporary power failure, it uses the same
settings before the power was cut off.
85464609338010_01_EN.fm Page 7 Wednesday, September 2, 2015 12:09 PM
Summary of Contents for U-26PE1U6
Page 22: ...22 ...
Page 23: ...23 ...
Page 24: ...85464609338010 BE0915 0 Panasonic Corporation 2015 Printed in Japan ...
