15
English
6. Mounting the plasma display onto the
wallhanging bracket and connecting it to
the other components
Remove the red-marked pivot fixing/releasing screws
on the
left and right (one at the left and one at the right).
Fit the insulation spacers at the top of the plasma display onto
the cutouts at the top of the wall-hanging bracket, and lower
the plasma display.
Pull the plasma display toward you as shown in the figure on
the right, and connect it to the power cord and the cables of
other components.
After completing the connections, lift the plasma display
slightly, and insert the lower insulation spacer into the hole at
the lower part of the wall-hanging bracket.
Now lower the plasma display.
Cutout
at top
Upper insulation spacer
Red-marked pivot
fixing/releasing screw
Hole at bottom
Lower insulation
spacer
Surface of wall
Surface of wall
CAUTION
• If the plasma display is lifted too much, its top part will become
disengaged from the wall-hanging bracket.
7. Anchoring the plasma display
Install the accessory screws for securing unit
(2) into the
mounting holes of the screws for securing unit on the sides
(left and right) of the wall-hanging bracket.
Securely tighten the removed red-marked pivot fixing/releasing
screws
(one at the left and one at the right) in the mounting
holes of the red-marked pivot fixing/releasing screws on the
sides of the wall-hanging bracket.
(Tightening torque: 1.2 to 1.5 N•m)
Hole for mounting the
screw for securing unit
Screw for securing unit
Mounting hole for red-marked
pivot fixing/releasing screw
Wall-hanging bracket
Red-marked pivot fixing/releasing screw
Surface of wall
Note
• In order to prevent the plasma display from becoming disengaged
from the wall-hanging bracket, the screws for securing unit
must
be securely tightened at the left and right as far as their bases.
How to remove the plasma display from the
wall-hanging bracket
Remove the screws for securing unit
(one at the left and one
at the right) which are mounted on the sides of the wall-hanging
bracket.
Disconnect the power cord and the wires connecting the plasma
display to the other units.
While lifting the bottom part of the plasma display, pull the plasma
display toward you.
After the bottom insulation spacers have been removed, continue
lifting up the plasma display and remove it.
Lower insulation
spacer
Screw for securing unit
Surface of wall
Surface of wall
Note
• The plasma display needs to be lifted up approximately 4 cm (1.6
inches) to be removed.
