Panasonic TH-65EF1E, Operating Instructions - Basic Manual

Page: 8 / 25

English
8
Do not step on, or hang from the display.
•
They might tip over, or might be broken and it may
result in injury. Pay special attention to the children.
Do not reverse the polarity (+ and -) of the battery
when inserting.
•
Mishandling the battery may cause its explosion
or leakage, resulting in fire, injury or damage to
surrounding properties.
•
Insert the battery correctly as instructed. (see page
11)
Do not use batteries with the outer cover peeling
away or removed.
(The outer cover is attached to the battery for safety.
It must not be removed. Doing so may cause short
circuits.)
•
Mishandling the batteries may cause the batteries
to short circuit, resulting in fire, injury or damage to
surrounding properties.
Remove the batteries from the remote control
transmitter when not using for a long period of time.
•
The battery may leak, heat, ignite or burst, resulting in
fire or damage to surrounding properties.
Do not burn or breakup batteries.
•
Batteries must not be exposed to excessive heat such
as sunshine, fire or the like.
Do not turn the Display upside down.
Do not position the unit with its liquid crystal panel
facing upright.
Precautions for use
Cautions when installing
Do not set up the Display outdoors.
•
The Display is designed for indoor use.
Install this unit at a location which can support the
weight of the unit.
•
Use the installation bracket that conforms to VESA
standards
Environmental temperature to use this unit
•
When using the unit where it is below 1 400 m (4 593
ft) above sea level: 0 °C to 40 °C (32 °F to 104 °F)
•
When using the unit at high altitudes (1 400 m (4 593
ft) and higher and below 2 800 m (9 186 ft) above sea
level): 0 °C to 35 °C (32 °F to 95 °F)
Do not install the unit where it is 2 800 m (9 186 ft)
and higher above sea level.
•
Failure to do so may shorten the life of the internal
parts and result in malfunctions.
We are not responsible for any product damage, etc.
caused by failures in the installation environment
even during the warranty period.
Do not place the display where it may be affected by
salt or corrosive gas.
•
Failure to do so may shorten the life of the internal
parts and result in malfunctions due to corrosion.
Required space for ventilation
•
For the outermost periphery of the display, leave a
space of 10 cm (3.94”) or more at the top, bottom, left
and right.
At the rear, leave a space of 5 cm (1.97”) or more.
About the screws used when using a wall hanging
bracket that conforms to VESA standards
Inch
model
Screw pitch for
installation
Depth of
screw
hole
Screw
(quantity)
65 400 mm × 400 mm 14 mm M6 (4)
Be careful of the movable structure of the power
indicator and remote control sensor.
•
As factory default, the power indicator and remote
control sensor are stored in the main unit. For normal
use, pull out the remote control sensor from the edge
side of the main unit by operating the lever on the
rear panel. Depending on the setup condition such as
when using the multi display, store the remote control
sensor in the main unit. (see page 15)
Do not grab the liquid crystal panel.
•
Do not forcibly press the liquid crystal panel, or push
it with a pointed object. Applying a strong force to
the liquid crystal panel will cause unevenness of the
screen display, resulting in malfunction.