1/2
SIGNAL
INPUT LABEL
WOBBLING
SET UP
POWER MANAGEMENT
ON
OFF
STANDBY SAVE
ON
ECO
OFF
OSD LANGUAGE
ENGLISH (US)
COMPONENT/RGB-IN SELECT
RGB
NO SIGNAL POWER OFF
ENABLE
NO ACTIVITY POWER OFF
DISABLE
SCREENSAVER
32
Reduces power consumption
Press to select the menu to adjust.
Press to select “ON (ENABLE)” or “OFF (DISABLE)”.
ON (ENABLE)
OFF (DISABLE)
Press to exit from SET UP.
• POWER MANAGEMENT:
When this function is set to ON, it operates under the following conditions to turn the power
on or off automatically.
When no pictures are detected for 30 or so seconds during PC signal input:
Power is turned off (standby); the power indicator lights up orange.
When pictures are subsequently detected:
Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during input from PC IN terminal.
•
This function is effective when “SYNC” is set to “AUTO” and during normal viewing (one
picture screen).
• NO SIGNAL POWER OFF:
Equipment power supply is turned OFF when there is no signal.
When this is set to “ENABLE”, the power supply of the unit goes Off 10 minutes after the
input signals stop.
Note:
This function is effective during normal viewing (one picture screen).
• NO ACTIVITY POWER OFF:
When this function is set to “ENABLE”, the power is turned off (standby) automatically when
there is no operation of the Display for 4 hours.
Starting from 3 minutes before the turn off, the remaining time will be displayed.
NO ACTIVITY POWER OFF
3MIN
PRESS ANY KEY TO ABORT.
When the power is turned off due to this function, a message “LAST TURN OFF DUE TO
’NO ACTIVITY POWER OFF’.” is displayed next time the power is turned on.
Note:
During the screensaver is running, this function is disabled.
• STANDBY SAVE:
When this function is set to “ON”, serial communication is disabled during standby mode,
reducing the power consumption during standby.
To perform serial communication while in standby, set this function to “OFF(SERIAL)”.
However, the standby power consumption is greater than when it is set to “ON”.
Note:
The factory setting is “ON”.
• ECO:
This function adjusts the brightness of the backlight to reduce power consumption.
OFF: This function does not operate.
ON: Backlight brightness is reduced.
SENSOR: The backlight brightness is automatically adjusted according to the viewing
environment.
Note:
When this function is set to “ON” or “SENSOR”, the “BACKLIGHT” setting in the PICTURE
menu is disabled.
1
2
3
