- 16 -
Remote Contr
ol T
ransmitter
Inserting batteries
1
.
Open the cover of the battery
compartment, located on the back of
the remote control unit.
2
.
Insert the batteries in the compartment,
paying attention to correct polarities, as
shown in the illustration.
3
.
Close the battery compartment, sliding
the cover in place.
Precautions when using batteries
The incorrect insertion of batteries in the
compartment can cause leaking and
corrosion of metal parts, and may Observe
the following precautions:
1
.
Batteries should be replaced in pairs.
2
.
Do not mix new and used batteries.
3
.
Do not mix differ
ent types of batteries
(for example, carbon-zinc with alkaline
batteries).
4
.
Do not attempt to charge, short-circuit,
open, warm up or burn used batteries.
5
.
Remove the batteries from the unit, if
the unit is not going to be used for a
long while.
Note:
Once discharged, the batteries included with this product may be disposed
off with domestic trash.
Useful Suggestions:
R
eplace batteries when noticing any
failure in the functioning of the remote
control unit.
If the remote control is frequently used, we
recommend the use of alkaline batteries,
with longer life.damage the unit.
COVER
PUSH AND
PULL TO
OPEN THE
COVER OF
THE BA
TTER
Y
COMP
AR
TMENT
POLARITY
TC-20G12P / TC-29G12P / TC-29G12PU
Operation Guide
Summary of Contents for TC-29G12P
