6
TQ
BJ
09
76
6
2
Connect the speakers.
Connect the speaker cables to the terminals of the
same colour.
3
Connect the AC mains lead.
Do not use any other AC mains leads except the
supplied one.
Conserving power
The system consumes a small amount of power even
when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Overview of controls
Do the procedures with the remote control. You can also use the buttons on the main unit if they are the same.
A
Standby/on switch
[
`
],
[
1
]
Press to switch the unit from on to standby mode or
vice versa. In standby mode, the unit is still
consuming a small amount of power.
B
Select the audio source
On the main unit:
To start Bluetooth
®
pairing, press and hold [
].
C
Basic playback control
D
View the setup menu
E
View the content information
F
Select or confirm the option
G
Open or close the disc tray
H
Decrease the brightness of the display panel
The illumination is also switched off.
To cancel, press the button again.
I
Adjust the volume level
J
Mute the sound
To cancel, press the button again.
“MUTE” is also cancelled when you adjust the volume
or when you switch off the system.
K
View the play menu
L
Select the sound effects
M
Select the jukebox
N
Display panel
O
USB port (
)
P
Disc tray
Q
Remote control sensor
Distance: Within approximately 7 m
Angle: Approximately 20° up and down, 30° left and
right
Be careful not to cross
(short-circuit) or reverse the
polarity of the speaker wires
as doing so may damage the
speakers.
Red
Black
(For the AC mains plug of three pins)
READ THE “Caution for AC mains lead” BEFORE
CONNECTION.
SC-UX102.100 E TQBJ0976 (01) En.fm Page 6 Tuesday, September 13, 2016 10:30 AM
