6
RQ
T
X
11
68
Getting S
tarted
Playing
Discs
Ot
her Op
era
tions
Reference
How you set up your speakers can affect the bass and the sound field.
Note the following points:
≥
Place speakers on flat secure bases.
≥
Placing speakers too close to floors, walls, and corners can result in
excessive bass. Cover walls and windows with thick curtains.
≥
For optional wall mount, refer to page 16.
[Note]
Keep your speakers at least 10 mm away from the system for proper
ventilation.
Setup example
(Recommended:
5.1ch layout
)
Place the front, center, and surround speakers at approximately the same
distance from the seating position. The angles in the diagram are
approximate.
§
1 Position with at least 5 cm of space on all sides for proper ventilation.
§
2 Put on a rack or shelf. Vibration caused by the speaker can disrupt
the picture if it is placed directly on the TV.
§
3 Place to the right or left of the TV, on the floor or a sturdy shelf so that
it will not cause vibration. Leave about 30 cm from the TV.
Depending on the room layout, you may like to use only the front
speakers and subwoofer for space saving (
2.1ch layout
).
Notes on speaker use
≥
Use only supplied speakers
Using other speakers can damage the unit, and sound quality will be
negatively affected.
≥
You can damage your speakers and shorten their useful life if you play
sound at high levels over extended periods.
≥
Reduce the volume in the following cases to avoid damage:
– When playing distorted sound.
– When the speakers are reverberating due to a record player, noise
from FM broadcasts, or continuous signals from an oscillator, test
disc, or electronic instrument.
– When adjusting the sound quality.
– When turning the unit on or off.
If irregular colouring occurs on your TV
The center speaker is designed to be used close to a TV, but the picture
may be affected with some TVs and setup combinations.
If this occurs, turn the TV off for about 30 minutes.
The demagnetising function of the TV should correct the problem. If it
persists, move the speakers further away from the TV.
Turn off all equipment before connection and read the appropriate
operating instructions.
Do not connect the AC mains lead until all other
connections are completed.
§
5.1ch layout only (
B
left)
[Note]
Be careful not to cross (short circuit) or reverse the polarity of the
speaker wires as doing so may damage the speakers.
step 1
Positioning
Caution
≥
The main unit and supplied speakers are to be used only as
indicated in this setup. Failure to do so may lead to damage to
the amplifier and/or the speakers, and may result in the risk of
fire. Consult a qualified service person if damage has occurred
or if you experience a sudden change in performance.
≥
Do not attempt to attach these speakers to walls using methods
other than those described in this manual.
120°
60°
Center speaker
§
2
Front speaker
(left)
Subwoofer
§
3
Surround
speaker (left)
Surround
speaker (right)
Front speaker
(right)
Main unit
§
1
step 2
Connections
1
Speaker connections
Speaker (rear)
Refer to the rear label of the speaker before
connecting the appropriate cable. Verify the
type of speaker with the label on the rear of
the speaker.
Speakers
A
Cable type
5
Center speaker
§
CENTER / CENTRE
short
2
Front speaker (R)
FRONT / AVANT
1
Front speaker (L)
4
Surround speaker (R)
§
SURROUND /
AMBIOPHONIE
long
3
Surround speaker (L)
§
A
1
3
2
Connect the speaker cables. Insert the wire
fully, taking care not to insert beyond the wire
insulation.
i
: White
j
: Blue line
Main unit (rear)
White
Blue
line
White
Blue line
PUSH !
Surround
speaker (L)
Subwoofer
RQTX1168-G_eng.book Page 6 Friday, April 23, 2010 4:28 PM
